Bright Works

Such as: aluminum intakes and water pumps or a number of other parts. You are able to get into, over and around many areas that spiral buffs can not reach. Most often used with Tripoli compound on soft metals, although may be used with any type of compound. The yellow treatment provides a more aggressive buffing action than the standard Air-Flex buffs and helps retain compounds.

Kit shown above has 6 wheels. Also available are 8" and 10" kits. Kits include; two Spiral sewn buffs, two Loose sewn buffs, a half bar of Tripoli and a half bar of Color buffing compound and complete instructions. All buffing wheels in these kits are 1/2 wide. Kits include; two Spiral sewn buffs, two Loose sewn buffs, a half bar of Stainless and a half bar of Color buffing compound and complete instructions.

Simply slip the motor arbor over your non threaded motor shaft and tighten the set screws. NOTE, all motor arbors have a 1/2" - 20 fine thread x 1-11/16" long threaded end for mounting buffing wheels to and a over all length of 3-3/8''. The washers are 1/8'' thick and the nut is 5/16'' thick. Choose right or left hand threads and your non threaded shaft size of 1/2" or 5/8".

Except for new buffs, most buffing wheels should be raked out before each use and periodically during use, to break down and remove old compound and metal particles. The bristles on a wire brush will provide a much finer raking action on the face of the buff. This will break down the old compound and metal particles much smaller without tearing into the cloth, while leaving a finer uniform nap finish on the buff. Simply use a wire brush to rake over the face of the wheel and around each side about a 1/2.

Also used for porting heads. Rolls are 1 long and in packs of ten. 1/4 diameter $3.49. 3/8 diameter $3.99. 1/2 diameter $4.29. For the best results use with Tallow Grease abrasive lubrication listed below. Please specify rolls size and grit below, available in 1/4", 3/8" & 1/2" diameter x 1" long & grits of 80, 120, 180, 240, or 320.